Game Hookups

Nintendo 64

Connecting to TV Using Stereo Audio/Video Cable Connecting to TV using the RF Switch and Modulator Set Connecting to VCR Using Stereo Audio/Video Cable Connecting to VCR using the RF Switch and Modulator Set

All Game Systems Nintendo GameCube Sony Playstation 2 PS One Game Console PlayStation Game Console Nintendo 64 Xbox

 

Connecting to TV Using Stereo Audio/Video Cable - Back to Top

1. Locate the Audio/Video inputs on the back of the TV.
2. Place the yellow end of the Stereo A/V cable into the VIDEO IN on the back of the TV. Connect the red end of the cable to AUDIO IN RIGHT. Connect the white end of the cable to the Audio "in" Left. Use a slight twisting motion when inserting the each cable and ensure the cables are firmly pressed into the input.
3. Connect the rectangular (gray) plug of the Stereo A/V cable into the MULTI OUT connector on the back of the Control Deck.

Connecting to TV using the RF Switch and Modulator Set - Back to Top

1. Locate the TV's VHF IN [ANT, CATV, 75S(ohm)] or Cable Connector.
2. Remove existing cable wire from TV's VHF IN.
3. Connect the short, thick wire (labeled TV) of RF Switch to VHF IN.
4. Connect existing cable wire to the silver post labeled ANT on RF switch.
5. Plug the RF Modulator into the MULTI OUT connector on the back of the system
6. Connect the thin wire (labeled Control Deck) of the RF Switch to the RF Modulator (labeled RF Out).
7. Set the switch labeled 3/4 of the RF Modulator to either 3 or 4 and then match the channel of the TV to 3 or 4.

Note: The RF Modulator does not produce stereo sound. To get stereo sound, connect your Control Deck to your TV or VCR using the Stereo Audio/Video Cable.

Connecting to VCR Using Stereo Audio/Video Cable - Back to Top

1. Locate the Audio/Video inputs on the back of the VCR.
2. Place the yellow end of the Stereo AV. Cable into the VIDEO IN on the back of the VCR. Connect the red end of the cable to AUDIO IN RIGHT. Connect the white end of the cable to the AUDIO IN LEFT. Use a slight twisting motion when inserting the each cable and ensure the cables are firmly pressed into the input.
3. Connect the rectangular (gray) plug of the Stereo AV. Cable into the MULTI OUTconnector on the back of the Control Deck.

Connecting to VCR using the RF Switch and Modulator Set - Back to Top

1. Locate the VCR's VHF IN [ANT, CATV, 75S(ohm)] or Cable Connector.
2. Remove existing cable wire from VCR's VHF IN.
3. Connect the short, thick wire (labeled TV) of RF Switch to VHF IN.
4. Connect existing cable wire [previously removed] to the silver post (labeled ANT) [Cable Connector] on RF switch.
5. Plug the RF Modulator into the Multi Out connector on the back of the N64
6. Connect thin wire of the RF Switch (labeled Control Deck) to the RF Modulator (labeled RF Out).
7. Set 3/4 switch of the RF Modulator to match the 3/4 channel of the VCR. Note on Sharp TV/VCR Combo.